TerraGuard 106 P

TerraGuard 106 P
Turf Reinforcement Mat

TerraGuard 106P is a three dimensional geosynthetic mat made up of polypropylene fibers parallel stitched between a high strength, biaxially oriented net, and mechanically bound together by parallel stitching with polyolefin thread. The matrix possesses strength and elongation properties to limit stretching in a saturated condition. TerraGuard 106P is UV stabilized and is inert to chemicals normally found in a natural soil environment. TerraGuard 106P conforms to the following properties after a 24 hour saturation period.

PROPERTY	TEST METHOD	MINIMUM AVERAGE	TYPICAL AVERAGE

*Mechanical*
Tensile Strength	ASTM D 5035	220 x 165 lb/ft	335 x 230 lb/ft
Tensile Elongation	ASTM D 5035	40% max	25 %
Tensile Strength @ 10% Elon.	ASTM D 5035	n/a	145 x 110 lb/ft

*Endurance*
UV Resistance @ 1000 hrs	ASTM D 4355	80 %	90 %

*Physical*
Mass Per Unit Area	ASTM D 5261	14 oz/yd²	14.5 oz/yd²
Thickness	ASTM D 1777	.60 in	.70 in
Resiliency	ASTM D 1777	80 %	90 %
Moisture Absorption	ASTM D 570	0.01 % max	0.01 %
Porosity	Calculated	95 %	95 %
Ground Cover Factor	Light Projection	60 %	75 %

*Performance*
Velocity		-----	14 ft/sec
Shear Stress		-----	5 lbs/ft²

Minimum Average Roll Values (typical value minus 2 std. deviations). Resiliency defined as percent of original thickness retained after 3 cycles of a 100 psi load for 80 seconds followed by 60 seconds without load; thickness measured 30 minutes after load removed by ASTM D-1777. Porosity calculation based upon mass per unit area, thickness, and specific gravity. Ground cover factor represents “% Shade” from Lumite Light protection Test. Tensile strength retained after 1000 hours in Xenon ARC Weatherometer. Performance represents maximum permissible design values based on long term (50hrs), vegetated data obtained at an independent hydraulics testing facility. STANDARD ROLL SIZE - 7.5’ x 120’ (100 yd2) WEIGHT - 63 lbs /roll

Phone: +1.800.438.0027

Fax: +1.704.394.7946

6509-C Northpark Blvd.

Charlotte, NC 28216

e-mail: info@webtecgeos.com